97300 Waste Gas Burner

The S&J 97300 Waste Gas Burner is designed to combust biogases generated in fermentation processes. It efficiently incinerates low BTU gases from anaerobic digesters, lagoons, and municipal landfills, minimizing odors and VOC’s. The stoichiometric pilot ensures that a proper air to fuel mixture is maintained throughout the wide range of pressure and BTU fluctuations. A continuous burning pilot in the flame area provides stable, controlled, nonsmoking, combustion.

The 97300 is designed to withstand wind speeds up to 150mph as well as seismic zone 4 loads. Its stainless steel components endure the severest of process environments. The burner tip is designed with swirl inducers that create a cyclonic effect producing an efficient air/fuel mixture and maximizes flame retention. The wind shroud induces sufficient air to the flare tip for proper mixing and combustion throughout the operating range.

The Pilot Control Box includes selector switches for the powering, resetting, and emergency stopping of the unit. It also includes indicator lights for power and flame proven.

The Pilot Control Box utilizes state of the art electronics and instrumentation for safe operation. Pilot controls are enclosed in a NEMA 4, carbon steel, electrical enclosure (NEMA 4X, 304 or 316 optional). For automatic operation, the flare’s pilot can be designed to operate only during initial startup or continuously. The Pilot Control Box includes a dry contact input for Remote Start from a SCADA system or a pressure switch. It also includes Contact Status outputs for Alarm and Flame Proven.

The auto-ignition sequence is started by the closing of the remote start contact or pressure switch contact. This will indicate that the gas pressure limit has been reached and flaring of excess gas should begin. The operation of the burner will continue until the contact opens.

Benefits

  • High Performance Stoichiometric Pilot
  • No Flame Front Burn-out of Pilot Gas During Ignition
  • Sizes 2” Through 12”
  • Burns High Flow, Low BTU “Wet” Methane
  • No Venturi Maintenance
  • State-of-the-Art Digital Control
  • Fully Automated Pilot: Continuous or Intermittent While Flaring
  • Provides Alarm Outputs
L&J Technologies or any of it’s subsidiaries assume no responsibility and shall not be liable for any damage, injury or death caused by the mis-application or improper installation of the products that it provides. Installation shall be per manufacturer’s instructions in accordance to any applicable local, state or federal regulations. It is the responsibility of the purchaser to ensure these guidelines are followed and that the products are applied properly.

Related Products

97300M Waste Gas Burner

97300T Waste Gas Burner With Touch Screen Control Panel