97311 Enclosed Burner

Shand & Jurs Biogas 97310 Enclosed Burner PDF
  • No Visible Flame

  • Controlled Combustion Environment Including Natural Draft Design

  • Meets Emission Standards of EPA & Local Regulations

  • High Destruction Removal Efficiency

  • High Turn Down Ratios

  • Ground Level inspirating venturi pilot/ignition lines

  • Operates with Low-Input Pressures


The Shand & Jurs Biogas Enclosed burner incinerates harmful emissions from waste gas streams. Typical applications include fermentation off gas piping systems such as anaerobic digesters or landfill gas. This unit has no visible flame which makes it ideal for residential areas.

The 97311 was specifically designed to completely combust gas in digester and landfill systems. The 97311 is uses maximum destruction efficiency (99%) and provides low NOX and CO emissions. This burner is ideal for environments that have strict emission requirements and regulations (such as the EPA) and keeps emissions within the allowable limit. The 97311 draws in the proper amount of air to gas ratio to achieve the optimum operating temperature in order for complete combustion to occur. Key data is used to determine the appropriate residence time of the waste gas inside the stack. This is critical to both the reliability of the emissions removal as well as the efficiency of operation.

The Automatic Ignition System accepts a remote contact or a signal from a pressure sensor to initiate ignition sequences. Advanced pilot design including UV sensors for positive flame proofing is available. Pilot System includes pilot pressure regulators and shut-off valves as specified.

The S&J 97311 can be configured with any combination of measuring instruments for complete recording and reporting. Flexible operation is achieved through innovative hardware design.

The design of the 97311 flare eliminates the need for refractory lining in the combustion chamber.

The S&J 97311 accommodates fluctuating gas stream composed of low BTU "wet" methane. It can withstand the severest of process environments including high wind loading and seismic conditions as specified.



L&J Technologies or any of it's subsidiaries assume no responsibility and shall not be liable for any damage, injury or death caused by the mis-application or improper installation of the products that it provides. Installation shall be per manufacturer's instructions in accordance to any applicable local, state or federal regulations. It is the responsibility of the purchaser to ensure these guidelines are followed and that the products are applied properly.