97200 Flame Check

The S&J 97200 Flame Check provides an in-line barrier against flame flashback in small gas lines. They are typically installed in pilot lines supplying fuel burning devices used in flares and waste gas burners. They are also used in vent piping servicing manometer pressure taps and diaphragm regulators.

Optimally, the flame check should be located as close as possible to the open end of the vent pipe or to the potential source of the flame. The flame check quenches in-line fires by lowering the gas temperature to below its ignition point. The 97200 provides safe, reliable fire protection with a woven wire design.

The flame check allows maximum flow with minimal pressure drop. It is also easily serviced and installed with pipe union housing.

Its aluminum and stainless steel components withstand the severest of process environments. The S&J 97200 is especially designed for hydrogen sulfide and hot, wet methane which are the main components of digester gas streams in municipal waste water treatment facilities.

Benefits

  • Flame Flashback Prevention
  • High Flow Capacity
  • Standard Stainless Steel
  • Sizes 1/4″ Through 2″
  • 25 PSIG Working Pressure
L&J Technologies or any of it’s subsidiaries assume no responsibility and shall not be liable for any damage, injury or death caused by the mis-application or improper installation of the products that it provides. Installation shall be per manufacturer’s instructions in accordance to any applicable local, state or federal regulations. It is the responsibility of the purchaser to ensure these guidelines are followed and that the products are applied properly.

Related Products

97301 Waste Gas Burner

97150 Single Port Regulator