94406 Vertical In-Line Deflagration Flame Arrester

Shand & Jurs 94306 Vertical In-Line Deflagration Flame Arrester
View Data Sheet (.PDF)

  • ISO 16852 Approved

  • ATEX EN 12874 Approved

  • Unitized tube bank design

  • Maximum protection and efficiency with minimum pressure drop

  • Wide range of standard construction materials

  • Easy inspection and maintenance, due to simple removal of tube bank

  • Complete range of flange sizes from 2” (50 mm) to 12” (300 mm) ANSI,EN1092, JIS. Consult factory for larger sizes

  • Optional Insulation Jackets Available

94407 Horizontal In-Line Deflagration Flame Arrester

Shand & Jurs 94307 Horizontal In-Line Deflagration Flame Arrester
View Data Sheet (.PDF)
  • ISO 16852 Approved

  • ATEX EN 12874 Approved

  • Unitized tube bank design

  • Maximum protection and efficiency with minimum pressure drop

  • Wide range of standard construction materials

  • Easy inspection and maintenance, due to simple removal of tube bank

  • Complete range of flange sizes from 2” (50 mm) to 12” (300 mm) ANSI,EN1092, JIS. Consult factory for larger sizes

  • Optional Insulation Jackets Available




L&J Technologies or any of it's subsidiaries assume no responsibility and shall not be liable for any damage, injury or death caused by the mis-application or improper installation of the products that it provides. Installation shall be per manufacturer's instructions in accordance to any applicable local, state or federal regulations. It is the responsibility of the purchaser to ensure these guidelines are followed and that the products are applied properly.