Detonation Flame Arresters

94311, 94312, 94313, 94314 Detonation Flame Arresters
  • Withstands instantaneous pressure at the flame front in excess of 500 psig

  • Tube bank design ensures consistent functioning

  • Carbon steel or 316SS housing construction, 316SS tube bank

  • Optional fittings for pressure taps or temperature probes

  • Standard drain plug

Model
Agency Approvals
94311
NEC GRP D / F.M.
94312
NEC GRP D MARINE / F.M., UCG
94313
NEC GRP C & D / F.M.
94314
NEC GRP C & D MARINE / F.M.



The Shand & Jurs Detonation Flame Arresters provide protection against flame propagation through piping runs and vapor recovery systems, while allowing maximum flow efficiencies. This design quenches a flame front approaching from either direction, even if it has transitioned to a detonation. The Arresters contain a detonation while retaining the integrity of both the arresting element and the housing. This is ensured by the design of the passages in the tube bank and the detonation resistant construction.

Standard construction of the housing is available in Carbon Steel or 316 Stainless Steel. The tube bank is Stainless Steel throughout. Special construction materials to withstand the corrosive actions of some vapors and atmospheric conditions are available upon request.


These models are available in a range of sizes from 2" through 24". Additional sizes available upon request. Standard connections are ANSI 150lb. or 300lb. Class raised face flanges.


L&J Technologies or any of it's subsidiaries assume no responsibility and shall not be liable for any damage, injury or death caused by the mis-application or improper installation of the products that it provides. Installation shall be per manufacturer's instructions in accordance to any applicable local, state or federal regulations. It is the responsibility of the purchaser to ensure these guidelines are followed and that the products are applied properly.